Stinkbug

Thanks mate.

I have a late 75 2 seater. it seems I have kdfl-08 springs in the front. They are the 240z part number. I’m trying to figure out if the kdfl-04 (260z) part number are taller and will give me the extra inch or so I need to raise the front. Confusing business this……

Hey brains trust. im looking at putting coilovers in front of my 260z. I have 55mm struts at the moment but have the opportunity to buy a pair of 51mm complete with stub axle and caliper mounts already attached. will they bolt straight in? Or is there a difference between the larger strut? thanks.

Very happy to report that I got the engine compliances today. 2 days before the emission testing exemption expired. happy days!

Not yet mate. Coming soon though.

Happy to report after chasing a terrible knocking noise that turned out to be a worn rocker my zed is now ready to roll. been on a couple of drives around the block which is 4km and somewhat resembling mt panorama I can say it goes great. Heaps of power, pretty much the same go as the v8. thanks to all who offered advice along the way. Much appreciated. Also a big shout out to Stewart Wilkins who never failed to get me bits overnight and for the help he gave me. Top guy.

I’m about 95% of the way now. made an exhaust today and got my wideband fitted in while I was under there. tomorrow if I don’t have work I’ll wire it all in and get that bit tidied up. getting so close now to taking it for a test drive.

Got her started today. Time to tidy up all the loose ends.

It is a 240mm flywheel I just put in. Must be out of a l28et?

Slowly chugging along. Started the wiring today. Only need to sort out a fuel return line and exhaust now. Got the clutch sorted out thanks to Mr. Wilkins. Ended up going with a 280zx flywheel and a VL clutch. Gotta say we are lucky we have guys like him around. Intercooler all in. Sure is a tight fit. need to sort out the pcv setup. If anyone can offer any pointers ittd be much appreciated

Have a 260z flywheel for sale. has recently been machined and not used. Going with a 240mm setup instead 200$. Can get to Sydney or Brisbane but will need pickup from freight depot in those locations.

So you talkin maybe nsk-6052hd. Or 6052hdb?

Would a 280zx flywheel work? Or aren’t the 2+2 flywheels 240mm?

L series back where it belongs. not long now just have to sort clutch, fuel and Intercooler then wiring and hopefully it starts.

I wish I knew that earlier before I fkd around making it fit around it! Haha