ackent1
-
Posts
103 -
Joined
-
Last visited
-
Days Won
1
Content Type
Profiles
Forums
Gallery
Events
Articles
Media Demo
S30z Register
Store
Everything posted by ackent1
-
240Z Seats (Recovered), 5 Speed Transmission (Canberra)
ackent1 replied to Dallas's topic in Parts and Tools for Sale
Dallas is it a spline output shaft or flange? Adrian -
Installed these nearly a year ago, and there still tight! Door sits proud a few mm at bottom or the door, Might get a set from scotts as well if there better! Adrian
-
Should be able to make it, depending on work commitments and weather.
-
Z shop (USA ) have new ones but ther a bit pricey $175.00 http://www.thezstore.com/page/TZS/CTGY/SEL14
-
FYI You can buy new belts etc from Hemco industries in Ballarat
-
A low act!!! I may be able to help out with electronic security if you want to go down that path. Adrian
-
It was a pleasure Simon. Looking forward to seeing it at the 2011 Xmas BBQ
-
PM Sent
-
Sorry to see you sell it Stuart I would buy it back but I just spent $35000 building a new one. Good luck with the sale!
-
Done deal unless its raining
-
00330 mostly finished
-
-
From the album: Current 240 project
temp motor to come out in Feb 2011 for a modified 2.9L -
From the album: Current 240 project
-
I have 2 spare 1970 heater control panels. I bought one in pretty good nic (from Adelaide z car)and then decided to by a brand new one. $500USD Might not have all of the cables though. Let me know if you want me to chase it up further. Early Hatch trim (Reproduction)is available from motorsport auto
-
PM sent Re 260 G/box
-
Anyone know where I could get a new universal joint for the steering column? Thanks Adrian
-
H beam rods normaly in stock $1200 http://www.pureperformancemotorsport.com/shop/product_info.php?cPath=244&products_id=190
-
This one cost me over $600 in materials But considering I spent 9 months cutting out rust it was money well spent It was copied from the Zfactory design, ie portable can be sent to the sandblasters etc while on the rotisserie
-
This place is worth a look www.pureperformancemotorsport.com I have got some rods from PPM I am waiting on the Forged dome pistons they where at bit cheaper than SPS and they run tighter clearances 4032 aluminum, coated etc, they will do any design you want
-
From the album: Current 240 project
-
From the album: Current 240 project
-
Nissan still sell them $145 part# 72810-E4100 Picked up one last week Brighton Nissan
-
Anyone know where I can buy 88 to 90mm flat top pistons for an L28 with either 133 or 130mm rods. I would prefer hypertitectic or quality cast over forged if availible. A complete bottom end would also be considerd. Thanks Adrian
-
From the album: Current 240 project
