Engineering Approval - What Did You Forget To Do?

[PeterAllen]

After a loooooooooooooong build I'm just about ready to seek engineering approval.

 

I've been in contact with the engineer from the word go so I'm not expecting any drama with the big ticket items but I expect 'Murphy' to be there.

 

Did anyone who has been through an approval process have any annoying minor issues arise? Thanks.

 

[KatoKid]

Fingers crossed for you Pete......you're paving the way for me!

[PB260Z]

Yep, a blown number plate light bulb.

(I was to concerned with the big items to thoroughly check the little things)

 

Good Luck, I don't think you will need it.

Edited September 21, 2016 by PB260Z

[CBR Jeff]

Yep good luck Peter.

Hope all goes to plan.

 

Jeff

[Cozza]

As per the comments above, your attention to detail through this build has been exceptional. I'm sure you'll pass with flying colours.

 

Look forward to seeing some plates on her Mate.

[dat240z]

My prop valve knob had to be taken off to stop adjustment.  Other than that if youve been in contact regularly during the build itll be sweet.

[rb25240z]

My two issues were heat shielding to brake components and 115db exhaust. Baffle plate (with non penetrating bird poo welds for easy removal) fixed the noise issue. Aluminum plates and high temp sleeves fixed the heat issues. Mine wasn't interested in rego related stuff.