ZED660

From the TEP website: "Webers work best at approx 4 psi of fuel pressure (Not 2 psi like many of the older books stated.) and you need Volume not Pressure to keep the float bowl full.We ONLY use the Carter Rotary pumps. They are High Volume (60-70 GPH) but only 4 psi." Some other sites do list them as 4-6psi!

I fitted a Carter 4070 some years ago when I fitted my motor with Webers and haven't had any problems whatsoever. The attached link gives some info re the Carter and also their opinion of Facet fuel pumps. http://www.racetep.com/webfuelspark.html Cheers

Ever since I have owned my 260 (about 13 years) the clock has never worked and was only correct twice a day! Recently I pulled the dash out to be re skinned and whilst it was away I took the back off the clock and blew out some dust and gave the workings a light spray with a spray similar to WD40. After putting the dash back in I was sitting in the car one day and heard this ticking sound and realised the clock had started to work again!! The only problem now is that it is going fast. I think it is making up for lost time:)

Hi Gareth, Not that I am aware, I have had them for a few years and even then they were a special order through a friend.

Hi, I have for sale a set of Whiteline 24mm adjustable front and rear swaybars. Asking $300 the pair. Located in Sydney south prefer local pickup if possible. SOLD Geoff

Hi, I have for sale a set of Whiteline 24mm adjustable front and rear swaybars. Asking $300 the pair. Located in Sydney south prefer local pickup if possible. Geoff

No worries Eau Rouge is a very fast corner. The car sounded great, it seemed like a lot of fun for you and your passenger! Spa is certainly a very special track, not like a lot of the new computer designed circuits.

Check out this vid and make sure you have the headphones on! And another of the same car:

Moto3 always produces the best races and Miller has developed into a genuine Championship contender. The Honda's are a lot quicker this year but Miller has got great track skills and is not scared to have a go. He is the best we have at the moment to replace Casey Stoner, but Marquez is a class act and seems to get better each race!

Hi Andrew, I would suggest you speak with Stew Wilkins. He is away at the moment with the Sydney to London Rally but will back at work after the Anzac weekend. Geoff

No, sorry they have been sold!

Hi Peter, Thanks I'll check with Graham. Did you send him a handwritten note thanking him for taking them????? Geoff

Hi Al, Long time no hear! No, I sold the heater to 'Brabham' also on this site and he was fully clothed at the time George:) Geoff

Hi Peter, Thanks for organising a great morning! Great to meet 'Pommie' Mike and several others although I missed some as I had to leave early, hopefully we can do it again in the not to distant future. Thanks to George, Peter and PB for the pics. Hope the next door neighbour wasn't too peeved:) Geoff

Hi Peter, Seems like you have started something! I hope you have some parking wardens on standby in case everyone turns up! Rustic George may have to order in more eggs and bacon:)

I think 'Aussie Bob' had already headed to Spain by then Peter, shortly before his ultimate demise!

I forgot to mention I also have a 240 motor under the bench (negotiable) and the following extra items; Alloy top fan belt pulley, and blanks for fuel pump (not in photo) and front inspection plate on head - $70 Four new (still in wrappers) 260Z original wheel centre caps - $50 Four used (good condition) Z centre caps, not sure what they are off - $30 ITEMS PREVIOUSLY POSTED: Reskinned dash in quite good condition no bubbles of lifts, there are a couple of small scuff marks that will clean up ok - $500 with gauges, wiring and bezel or $450 minus gauges. The glovebox interior has been fabricated in aluminium to replace the original material. - SEVERAL INTERESTED ATM Pair of seats with rails, need refurbishing - $75 pr -SOLD Centre console in general good condition has the factory standard small crack in the corner near the ashtray! but is an easy repair. Has four small holes on the lhs where a previous owner has apparently attached something - $150 with small panel that hinges to give access to fuse block. One of the pins for this hinged section is broken and the demister switch is broken. - SOLD Fuse block $$20 I have the plastic cover for it somewhere!! - SOLD Heater/fresh air console with control cables, one knob is missing off one of the adjusters $25. The section where the radio fits has been modified by previous owner. Tail lights fair condition with wires $50 pr - SOLD Tail light garnish $$65 - HELD PENDING Fuel rail $20 Steering wheel $60 - SOLD Pair of original horns $20 Heater box $60 - SOLD Blower $60 - SOLD

Hi Gav, The dash came out of a '71 model and it has a hole for a cig lighter (I presume) on the dash just to the left and below the revcounter. In fact there are two impressions there and the cig lighter hasn't been installed since the reskin. I don't know who did the dash, I bought the car in 2000 and it was done then. The speedo is 0 -160 mph. The tail light garnish looks pretty straight a couple of dings on the inside but not too bad, it has a rough paint job on it but I think it would probably clean up ok. As I said, I would prefer people to look at items first before committing. To those who replied (George, acf, wa, Gav) I will send some more detailed pics via PM to you tomorrow. Geoff

Hi, I'm having a bit of a tidy up and have some 1971 240Z parts to move; As per the attached pictures; Reskinned dash in quite good condition no bubbles of lifts, there are a couple of small scuff marks that will clean up ok - $500 with gauges, wiring and bezel or $450 minus gauges. The glovebox interior has been fabricated in aluminium to replace the original material. Pair of seats with rails, need refurbishing - $75 pr Centre console in general good condition has the factory standard small crack in the corner near the ashtray! but is an easy repair. Has four small holes on the lhs where a previous owner has apparently attached something - $150 with small panel that hinges to give access to fuse block. One of the pins for this hinged section is broken and the demister switch is broken. Fuse block $$20 I have the plastic cover for it somewhere!! Heater/fresh air console with control cables, one knob is missing off one of the adjusters $25. The section where the radio fits has been modified by previous owner. Tail lights fair condition with wires $50 pr Tail light garnish $$65 Fuel rail $20 Steering wheel $60 Pair of original horns $20 Heater box $60 Blower $60 These parts are in Sydney and I wanted to give people here a look first before I advertise them elsewhere. They are pick up only and I would prefer anyone interested to check them out first. Please ask if you want further photos. Geoff

The first FOSC meeting for 2014 is fast approaching! Wakefield Park near Goulburn on the 4-6 April. Just putting it out there in case anyone is interested (any Mexicans??) The entry forms are available on the FOSC web site and we are trying to get sufficient numbers to run this event again. Everyone enjoyed the December meeting at SMP and it would be good if we could do it again!

Hi, No I sold them long ago, I gather they are unobtainable in the US now. Cheers.

Hey Gav, Just dont take it near Beecroft!

Last ones

A few more pics!

Well a great weekend was had by all with 16 Zeds lining up for a days competition. As some would expect (Jason), the Group Sc cars were quickest with James Flett doing 1.05.4, Chris Gray 1.05.9, Russell Stanford 1.06.1, the first road registered car was Greg Redman with a 1.07.2 followed by the rest in the 9's through to the 13's. Results are on Natsoft. I have attached a few pics and hopefully we can do it again next year.