New compliance plates or any kind of plates

[Corsa224]

 

Hi, just found this site in the state,

 

I'm going to give them a try and see how it goes

 

http://www.datatags.com/

 

If it works out well you can all thank me later lol

[RBZ 260]

even easier

 

http://www.zeddsaver.com/all_plates.html

[SS30RR]

wtf......hahah I love you.....I need this as my car looks dodgy without it.

 

do you know how much it costs?

[Corsa224]

 

I'm going to send him a sample then provide him all my info,

 

I just to locate an old compliance plate to send to him as the sample first

[Ledge]

Do Zeddsaver do HS30 ones or only HLS30

[Riceburner]

What are the legalities on this sort of thing? Sounds a bit dodgey but I'm from the nanny state 

[SS30RR]

I'm going to send him a sample then provide him all my info,

 

I just to locate an old compliance plate to send to him as the sample first

 

Very keen to see how you go.

[Corsa224]

The first guy has retired and referred me to this guy instead

 

http://www.NostalgicReflections.com/

[Corsa224]

The REPLY - This is for the Australian issued compliance plate, not the Datsun Build Plate

 

Chris,

I have been out of town for a few days. Sorry for the delay.

Yes!

I have your data plate here for your Datsun.

I can make you a new data plate. There are two ways to make it.

1. Stamped with a male & female stamping dies.

2. Deep acid etched

Both of these methods look the same from the front of the plate, but if you were to turn the etched one over, you would see that it was not stamped from the back side.

The stamped method is very expensive because we need to make the dies, and they are very time consuming. I can make it for you at a cost of $1,200.00.

The acid etched data plate will cost you $285.00 + 43.75 to stamp the numbers you need + $12.00 for insured shipping and handling to Australia.

[YosemiteZed]

Hi

Aegean who is a member had access to the Nissan plates see thread (post below)

 

http://www.viczcar.com/forum/index.php/topic,1776.msg26820/topicseen.html#msg26820

 

I got one from him to suit RHD S30

http://www.viczcar.com/forum/index.php/topic,6082.msg53739.html#msg53739

 

 

and for other plates and decals  try this site in the US

www.zzxdatsun.com/catDecals.php

Cheers

Phil

 

[Corsa224]

 

again this is not for the Datsun Plates in the link but for the Australian Compliance Plates,