Jump to content

oldzguy

Members
  • Posts

    82
  • Joined

  • Last visited

Everything posted by oldzguy

  1. Nice, you'll find the much recommended Mick at BP Dover, hope purchase goes well
  2. Welcome Mark, I can recommend Phil Young engine reconditioning in Grove Rd or Tas Engine reconditioning services in Sunderland St for rebuild or maybe even just a head surface, gasket set and get it going again? what area, (approximately) are you in? cheers Wayne
  3. If you take your door panel off you will see all the window frame mounting points are adjustable, then when thats done adjust the glass to suit, fiddly job. good luck
  4. Other car forums I use have a minimum post limit before you can use the classified section, idea maybe ?? This forum is a more supportive community than any other site I've been involved in, so don't change too much Cheers
  5. "Amazing how when you get to the end of your project on this site no one seems to give a shiver about your posts anymore. " WRONG!! the silent majority is always watching.....studying....learning
  6. OMG Loui me too!!! 'cept I've got 10 years over you young fella
  7. Welcome Linton, another bus, yeh, power to the bus people
  8. they are all inspirational vehicles to those of us without finished projects
  9. Got mine when Aussie dollar was near parity, cost $246 to my door & only took 10 days, thats for a 260 kit with rear sway bar too
  10. good luck if you do sell, hope it stays in Tas but
  11. Welcome to the "bus with sunroof" club
  12. oldzguy

    rear 1/4

    From the album: Oldzguy's lifetime project

    off with the old paint
  13. If you have a bench grinder you can make (and resharpen) ones like Katokid's picture from old drill bits, in any diameter you like, need a good square edge on grinding wheel but. I've done rear 1/4 panel and hatch slam panel ends with the one drill
  14. oldzguy

    No caption

    From the album: Oldzguy's lifetime project

    easier to fix what you can see
×
×
  • Create New...