NickF

Should have looked into this a bit more Have new boxes that didn't come with hinges

As above What to use for the hinges can't find any repros No idea what they look like Photos appreciated Thanks Nick

Thanks Don't need to fit locks/seals just set gap door/rear 1/4 and work from there?

Refitting the panels prior to painting. Fitted doors and have a </>5mm gap to rear quarters and to sill and swage lines line up (should I fit rubbers and door hardware?) Do I just work my way round the car and try to achieve an even gap?? I guess all panels have to be bolted up What kind of gap should there be between scuttle panel and wings also between inspection flaps and wings Also how to correct a slight taper to front of bonnet/wing one side only Advice /pictures welcomed Nick

Thanks need a longer tube

Hello Is there a bracket that holds the above tube in place and if there is any chance of a picture Thank you Nick

just been through this again and has proved invaluable regarding placement of battery tray and a few other things I wasn't sure of!! I spent a good deal of time cleaning the mastic from around the welded bolts for the steering column . obviously I shouldn't have done that. A couple of questions What to use to reseal the nuts? How are the bolts secured to the consul that the choke/throttle are bolted to Wonderfull Nick

Thank you Ordered one interesting to see what its like Nick

Refitting a battery tray that has been taken out and refitted previously Not sure where to fit it. The tray fits quite well above the welded on nuts on the fire wall and above the one on the inner wing. Ive seen picture where the nuts on the firewall were visible so Im not sure Any photos would be great Thanks Nick

Great job

thanks must be pedal end

Hello I want to fit new firewall grommet for the throttle shaft I guess need to remove the ball joint? (prefer not to) How forceful can I be (don't want to break) or will I be able to get grommet over ball joint? Looks like ball joint just pressed on? Hope I'm not over thinking this Nick

👍

👍

Hello Is the later 260 engine mount compatible with early 240 Thanks Nick