spiderken17 Posted May 3, 2011 Posted May 3, 2011 Since i have had very little interest in the car as a whole i have decided to break it up as parts (this way i get to keep the engine/gearbox for another project) The following items are from my 1977 260Z 2+2. I am located in the Lower Blue Mountains/ Penrith area. However, I am in St Marys often and go to Wetherill Park 2 days a week. I also travel up to Cessnock regularly and down to Ulladulla a few times a year. I will also be going down to Winton, VIC on the 19th of May for the V8's. If need be i can drop things off to any of these locations (or on the way) depending on timing to make things easier for buyers. I have the following items: Dash in excellent condition which is uncracked and has little to no marks on it - $400.00(cheaper than getting one reskinned) SOLD Centre console in excellent condition with little to no marks on it with rechromed ash tray lid - $180.00 SOLD Fibreglass front spoiler. Brand new in the plastic - $200.00 (cost me $250.00) SOLD Unmarked 14 inch alloy wheels with tyres (90% tread, 195 fronts, 205 rears) - $100.00 SOLD Rechromed passenger side footrest - $50.00 SOLD 7 inch round crystal headlights - $30.00 (retails for $50.00) SOLD All items are plus postage. Couriers to be organised by the buyer. The rest of the car is getting wrecked out on this thread http://www.viczcar.com/forum/index.php/topic,9088.msg87282.html#msg87282 Feel free to ask any questions. Contact me on spiderken17@yahoo.com.au Cheers, Ken Quote
slimerz Posted May 3, 2011 Posted May 3, 2011 Do you have the turn signal and headlight switch assembaly? If so how much? Also how much for the passenger side foot rest I saw on the other page? Thanks Mike Quote
luvemfast Posted May 3, 2011 Posted May 3, 2011 Do you have the turn signal and headlight switch assembaly? If so how much? Also how much for the passenger side foot rest I saw on the other page? Thanks Mike Hi Mike, Being that you're from the US..... The passenger side foot rest are acually the drivers pedals Here to help, the other Simon Quote
spiderken17 Posted May 4, 2011 Author Posted May 4, 2011 Also for sale Reproduction tailgate seal (on the body). This is not a length of rubber which needs trimming to fit but a closed loop of seal that fits the tailgate - $50.00 (cheaper than retail) SOLD Brand new Pierburg electronic 12 volt (6.3 to 8.1 psi) fuel pump. High quality. Part no. 3.45220.57 - $50.00 (retails for well over this) SOLD Quote
slimerz Posted May 4, 2011 Posted May 4, 2011 Im actualy going to convert a u.s. 240 to a RHD car. Thats why I'm so interested in these parts. The other part I would like to know a price on would be the steering column bracket. Thanks, Mike Quote
spiderken17 Posted May 5, 2011 Author Posted May 5, 2011 If possible could people please email me directly on spiderken17@yahoo.com.au with the part they are after as a heading, its confusing jumping from multiple forums to email keeping track of things. Cheers, Ken Quote
paulz Posted May 5, 2011 Posted May 5, 2011 Hi i will gladely buy the wheels ken regards Paul email already sent Quote
spiderken17 Posted May 7, 2011 Author Posted May 7, 2011 Did some sorting, here is a list of parts i still have to make things easier Bonnet - some surface rust and old repairs. SOLD LH/RH Guards - small amount of rust, some small dents. LH Door - stripped to bare metal, a few rust holes and small dents. not a bad door. Tailgate - no rust or damage. Bonnet Hinges - Good SOLD L26 Radiator and fan cowl - Worked fine when it was in the car L26 starter Motor - worked fine before the engine came out of the car LH/RH headlight surrounds - LH one looks good, RH appears to have some repairs on it LH/RH Headlight buckets - fine 7 inch Halogen headlights - H4 replacements for the old sealed beam units SOLD Tail lights/number plate lights/surrounds - Lenses, chrome surrounds and all the painted surrounds(stripped to plastic and painted in 2 pack, gunmetal grey) Grille - fine, could use a repaint LH/RH door stainless window frames - good LH/RH interior door opening mechanisms, handles and rods - works great LH/RH door window mechs and - good Washer bottle/ battery cover - mostly stripped, very good, no rust or repairs SOLD All Glass - frt screen (has a few chips), rear screen, LH/RH side glass, LH/RH qtr windows. Gauges - speedo (odo reads 96xxx kms), tacho, temp/oil, volts/fuel, clock, all worked when the car last ran bonnet cable - good with good bonnet release handle SOLD speedo cable - from speedo to gear box, good SOLD front/rear bars - both have some dents and marks, the rubber bump strips are cracked fuel flap - no dents SOLD L26 engine airbox - factory blue, some surface rust/ flaking paint stainless body moulds (door belt moulds, Qtr window appeture moulds, gutter moulds, windscreens and any other bits) - a few marks on some, most of them are near perfect. REAR SCREEN MOULD SOLD Feel free to ask any questions. If you are after pics email me so i cn email pics back as it is quicker and easier. Quote
spiderken17 Posted May 7, 2011 Author Posted May 7, 2011 More stuff LH/RH stainless window frames - good 2 steering wheels - both are rough and need a retrim front brake calipers - need a rebuild SOLD exterior door handles -a little worn SOLD washer bottle - not cracked but not perfect, just old Rolling Shell with all suspension/fuel tank/diff and C/V shafts - little bit of rust and old repairs (details here http://www.viczcar.com/forum/index.php/topic,9088.0.html) good if your shell is buggered, little bit of work and it would be a good shell. and if someone wants my interior for FREE they can have it. Alot of it is rubbish but some of the plastics are OK. Interior is pick up only ALL GONE Quote
wildy55 Posted May 8, 2011 Posted May 8, 2011 Have mailed you re lights and windscreen. Cheers Martin Quote
spiderken17 Posted May 12, 2011 Author Posted May 12, 2011 A few more things. LH/RH door metal window channels (in the door) - good Centre dash vent panel (where the centre console meets the dash) - a few small marks, pretty good Tailgate gas struts - still good 2+2 Tailshaft - good All badges in various conditions - not too bad Quote
spiderken17 Posted May 24, 2011 Author Posted May 24, 2011 Revised list of parts with prices Fibreglass front spoiler. Brand new in the plastic - $200.00 (cost me $250.00) LH/RH Guards - very small amount of rust, some small dents - $100 each LH Door - stripped to bare metal, a few rust holes and small dents. not a bad door - $80 Tailgate - no rust or damage - $150 L26 Radiator and fan cowl - Worked fine when it was in the car - $50 L26 starter Motor - worked fine before the engine came out of the car - $40 LH/RH headlight surrounds - LH one looks good, RH appears to have some repairs on it - $50 for the pair LH/RH Headlight buckets - fine - $20 for the pair Tail lights/number plate lights/surrounds - Lenses, chrome surrounds and all the painted surrounds(stripped to plastic and painted in 2 pack, gunmetal grey) - $100 the lot Grille - fine, could use a repaint - $20 LH/RH door stainless window frames - good - $25 each RH interior door opening mechanisms, handles and rods - works great - $20 Front screen - has a few chips $30 Rear Screen - good - $150 Speedo/Tacho - (odo reads 96xxx kms) - $50 each temp/oil, clock, all worked when the car last ran - $30 each front/rear bars - both have some dents and marks, the rubber bump strips are cracked - $20 each L26 engine airbox - factory blue, some surface rust/ flaking paint - $40 LH/RH Qtr window belt moulds - $20 each LH/RH gutter moulds - $20 each LH/RH door belt moulds - near perfect -$30 each Centre dash vent panel (where the centre console meets the dash) - a few small marks, pretty good - $20 Tailgate gas struts - still good - $20 the pair 2+2 Tailshaft - good - $30 LH door hinges - good - $30 the pair All badges in various conditions - not too bad - $30 the lot LH/RH Qtr glass in stainless frames - $30 each Front screen chrome moulds (goes in the screen rubber) Rolling Shell including all suspension/fuel tank/diff and C/V shafts - little bit of rust and old repairs, good if your shell is buggered, little bit of work and it would be a very good shell - detailed pics here http://www.viczcar.com/forum/index.php/topic,9088.0.html - $750.00 I can arrange transport for the shell if it is not too far from home. Feel free to ask any questions or about smaller items as i have everything bagged up. Quote
spiderken17 Posted May 31, 2011 Author Posted May 31, 2011 Airbox and grille sold Anyone interested in the shell as i would like it gone as i could use the space. Quote
FLEXZED Posted May 31, 2011 Posted May 31, 2011 Hey mate i would be interested in the radiator support before you get rid of the shell Loui Quote
spiderken17 Posted June 1, 2011 Author Posted June 1, 2011 The shell is going on ebay on thursday if anyone is interested. Quote
spiderken17 Posted June 4, 2011 Author Posted June 4, 2011 Shell is now on ebay. http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=260794522373&ssPageName=STRK:MESELX:IT I also found a Haynes manual and original factory manual. $10 plus postage for both. Quote
spiderken17 Posted June 14, 2011 Author Posted June 14, 2011 Manuals are sold. Also, someone can have the shell for $500 if they want it. Quote
spiderken17 Posted June 16, 2011 Author Posted June 16, 2011 Window mechs, door glass, LH door mech and fuel/volts gauge all sold. Quote
spiderken17 Posted July 11, 2011 Author Posted July 11, 2011 LH/RH Guards - very small amount of rust, some small dents - $100 each LH Door - stripped to bare metal, a few rust holes and small dents. not a bad door - $50 Tailgate - no rust or damage - $120 L26 Radiator - very good condition, little to no damage on the fins- $50 L26 starter Motor - worked fine before the engine came out of the car - $40 LH/RH headlight surrounds - LH one looks good, RH appears to have some repairs on it - $40 for the pair LH/RH Headlight buckets - fine - $20 for the pair Tail lights/number plate lights/surrounds - Lenses, chrome surrounds and all the painted surrounds(stripped to plastic and painted in 2 pack, gunmetal grey) - $100 the lot LH/RH door stainless window frames - good - $25 each RH interior door opening mechanisms, handles and rods - works great - $20 Front screen - has a few chips $30 Rear Screen - good - $120 Speedo/Tacho - (odo reads 96xxx kms) - $50 each temp/oil, clock, all worked when the car last ran - $30 each rear bar - has some dents and marks, the rubber bump strips are cracked - $20 LH/RH Qtr window belt moulds - $20 each LH/RH gutter moulds - $20 each LH/RH door belt moulds - near perfect -$30 each Centre dash vent panel (where the centre console meets the dash) - a few small marks, pretty good - $20 Tailgate gas struts - still good - $20 the pair 2+2 Tailshaft - good - $30 LH door hinges - good - $30 the pair All badges in various conditions - not too bad - $30 the lot LH/RH Qtr glass in stainless frames - $30 each Rolling Shell including all suspension/fuel tank - little bit of rust and old repairs, good if your shell is buggered, little bit of work and it would be a very good shell - detailed pics here http://www.viczcar.com/forum/index.php/topic,9088.0.html - $500.00 I can arrange transport for the shell if it is not too far from home. Feel free to ask any questions or about smaller items as i have everything bagged up. Quote
PZG302 Posted July 12, 2011 Posted July 12, 2011 Ken, Have just sent you a PM, I'll take the guards and headlight buckets off your hands. Will get me going again after my indescretion at Lakeside. Matt Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.