WTD: SU type carb throttle linkage (~165mm)

[Zedback]

Looking for the linkage between two SU type carbs, the shaft that links the throttle buterflys together.

They appear to be a later type (Hitachi?) SUs from a 260z with integral fuel bowls and a shaft length that looks about 20-25mm longer than the earlier type or about 165mm.

Mike

[sexual_sushi]

If they are the flat tops I might have one here you can have. I'll have to check on the weekend, it's burried behind a pile of sh!te atm. Would obviosuly have to check the length as well...

[sexual_sushi]

Looks like I may not have this part so if anyone else can help out, please let zedback know!

[peter t]

Will have that bit somewhere.

[zeds4ever]

;)Hi Zedback, I think I have what you are seeking,however this unit is 185mm in length. You can trim it down to your requirements ?.

Read your restoration project "Great" gained some useful info from it. You can have linkage for cost of postage. PM me re adress.

                                                                                          Regards :Alan.

[Zedback]

Thanks Alan, I'm hoping Peter T can find the right one and I can pick it up this weekend, if not I'll follow up on yours to modify.  Very glad you got some useful info from the project, I very much enjoy reading through others endeavours for the same reason.  Cheers, Mike

[zeds4ever]

:-\ How'd you go with linkage situation.

 

                                Regards :Alan.

[Zedback]

Thanks Alan, Got the one from Peter T which should be the correct one just haven't confirmed by fitting it.  Might not get to it this weekend if I get distracted bringing home yet another dead Z