Strut bracing 4 a 280 zx

[showtime]

I have upgraded my front and rear sway bars 28 front and 24 rear but i need strut bracing to finish me handling needs i have tried whitlane,vpw,nolathane and signature does any know who make them in Australia?

[nat0_240_chevZ]

i have made a zx one previously for a young chap here in adelaide.

dont have any templates etc as it was made to suit his car and as i had his car there i didnt need to. I think i have the drawings but for the strut tower tops.

bonnet clearance is a bit of a pita to get right, they were solid and in mild steel, ie no pivots fully welded.

 

nat0

[Hunter]

Cusco versions from MSA

http://www.thezstore.com/page/TZS/CTGY/PSDC04

 

They are a bit more expensive than the MSA versions I just bought for my 240Z, shipping is reasonable, and exchange rate should be ok at the moment.

 

I had US$920 worth of gear sent over in two big boxes from MSA, cost about $300 for postage.

 

For just two strut bars that should be a fair bit cheaper.