Jump to content

Recommended Posts

Posted

Ok so you need to do a bit of practice to be good at hillclimbs!

 

Think I will stick to the race tracks :)

 

Big thanks to Richard Monty (has a white 2+2) for giving me some straps to tie the car down on the way home! Well done on also kicking my but :)

 

Thanks also to lurch and Jane for there advice etc.

 

Ash

Posted

Slow

 

I only got 6 runs and really didnt learn the track down the bottom of the hill (still couldn't tell you which way it goes!)

 

I think my best time was my second run which was 66sec (about 3-5 sec slower than my car should be able to go)

 

I was going to blame my brakes but really they were not too bad (only had a little air in the lines when I bleed them today), I really comes down to learning the track.

 

Was good to finally open up the zed a little but cannot wait to get it on the track in a few weeks.

 

Ash

Posted

Glad to see you got some runs in, i found my spare coilover so i will have to set about putting it in before the next round.

Posted

You went slower after your second run? :( Glad we left after that one then :P You did really well considering you are still getting used to the car and don't know the track, so well done :) Look forward to watching your next run :)

Posted

Yer not sure what happened with going slower on the third run?

 

On the last run I was on a better lap but nearly lost it down the bottom of the hill and lost a stack of time.

 

Think I will put on a better show at Sandown in a few weeks :) (well not like my last visit to Sandown)

 

Ash

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...