WTB: 1973 240Z HEATER PANEL & Controls

[Hunter]

Desperatly needed to replace the aluminium panel that is installed currently.

 

[Hunter]

ANYONE AT ALL?

[Zed Brothers Inc]

http://cgi.ebay.com/ebaymotors/Datsun-240z-Map-Light-Vent-Heater-Control-Radio-Bezel_W0QQitemZ160281862604QQcmdZViewItem?hash=item160281862604&_trkparms=72%3A727|39%3A1|65%3A12|240%3A1318&_trksid=p4506.c0.m245

[Zedman240®]

I have a pretty average one here; broken at the bottom where the radio is if you are reaaallllyyyyy desperate..

[Hunter]

Yep I am that desperate..... send some pics...does it have the control levers etc?

[Hunter]

http://cgi.ebay.com/ebaymotors/Datsun-240z-Map-Light-Vent-Heater-Control-Radio-Bezel_W0QQitemZ160281862604QQcmdZViewItem?hash=item160281862604&_trkparms=72%3A727|39%3A1|65%3A12|240%3A1318&_trksid=p4506.c0.m245

 

Yep I seen that one, but is getting a bit rich when you add $50 postage on top. all I need is a working one so I can get the defroster working for registration.

[nizm0zed]

a 12v hair dryer wont suffice?

connect it to the ducts with a bit of gaff, and dodge up an on/off switch.

Instant roadworthy demister.

 

quite a few hotrods are done like this, and i did it in a mates car, and his engineer (and rego) had no probs at all with it.

[Hunter]

That will work for road worthy but I really do need the heaters as well. It is cold down here in Tassie.

 

I do have a blower motor etc, just need the front fascia.

[Zed Brothers Inc]

http://cgi.ebay.com/ebaymotors/1971-Datsun-240Z-Heater-Control-Panel_W0QQcmdZViewItemQQ_trksidZp1638Q2em122QQcategoryZ33692QQihZ011QQitemZ320303077158QQrdZ1QQsspagenameZWD2V

 

anothery 

[Zedman240®]

Hunter, sorry for the delay with the pic, but here it is. Found out its also missing the top half where the map reading lamp used to be.

[Hunter]

Pic looks better than what I have. How much do you want for it?

 

I have a few map lights and map light surrounds which should make it look reasonably neat.