Scotty_Rah Posted July 7, 2019 Share Posted July 7, 2019 I'm after a Passenger side floor pan. I'm in the Parramatta area. Quote Link to comment Share on other sites More sharing options...
C.A.R. Posted July 7, 2019 Share Posted July 7, 2019 Unlikely anyone in Australia will have reproduction late 260Z floor pans. You may have to import a pan from the USA for a 280Z. They don't rust as badly as 240Z floors, so how bad is the rust? Do you have photos? They could probably be repaired... Quote Link to comment Share on other sites More sharing options...
Scotty_Rah Posted July 7, 2019 Author Share Posted July 7, 2019 So, it was pretty bad. The previous owner had patched holes with fiberglass. So I went and cut all the bad parts out. I've now had it sitting like this for a few months, and I'm not sure how I'm going to replace the floor. I have sheet metal and a mig welder but I'm thinking theres gotta be a better way to do this.. any advice here is welcome. Quote Link to comment Share on other sites More sharing options...
C.A.R. Posted July 7, 2019 Share Posted July 7, 2019 Ahhh that's problematic, but not unrepairable. I suggest you follows Paul's tutorial as a guide: Take a paper template from the same area on the drives side, flip/mirror the pattern, then mark it out on some fresh sheet steel and start fabricating Scotty_Rah 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.