Wtb: Inner Cowl Panel.

[Andrew_L26]

I'm planning to remove my inner cowl panel (drill out spot welds etc.) so that I can wire wheel the lower water trap under the windshield and weld in a little patch where some rust has taken hold, the section that I am going to remove is pretty stuffed on my car and I think it would be best to just replace it. Anyone got one that I could buy?

 

http://www.hangoverture.com/240Z/UnderCowlRaw.jpg

 

Thats the part I'm after

 

Cheers,

Andrew

Edited June 29, 2016 by Andrew_L26

[gav240z]

Probably going to have to cut it out of another parts car yourself I'd imagine. Not the kind of part that most have laying around.

[Scoota G]

I sold a front cut to Matty Zed that had that part attached. He may not need it. I can ask if you like, he's down your way but be prepared to drill out about 183 spot welds.

[Andrew_L26]

I sold a front cut to Matty Zed that had that part attached. He may not need it. I can ask if you like, he's down your way but be prepared to drill out about 183 spot welds.

That would be fantastic, trust me, I've already drilled out my section and it's certainly a time consuming job! But it's worth it!

 

I've actually just cut around my service flaps so that I don't have to fiddle around aligning the brackets which should make it a fair bit easier.

 

Cheers,

Andrew

[Scoota G]

That would be fantastic, trust me, I've already drilled out my section and it's certainly a time consuming job! But it's worth it!

 

I've actually just cut around my service flaps so that I don't have to fiddle around aligning the brackets which should make it a fair bit easier.

 

Cheers,

Andrew

No worries i shall ask him.

[Andrew_L26]

No worries i shall ask him.

Hey mate, I was wondering if you've heard anything?

 

Cheers,

Andrew