Rolling Dolly Frames For S30 Shell For Sale

[dat2kman]

SOLD.

 

A front/rear set of sturdy frames, that attach to moustache mount pins at rear, and, front crossmember mount points at front.

These are height adjstable from side to side, to enable underside work to be done.

Compact design, unlike a rotisserie, and gives you ability to roll a bare shell around, or load it onto a trailer etc.

This was custom fabricated to suit the S30 bare shell, used in past for body prep, paint, roll cage install.

Comes complete, with its four height adjustable wheel posts,

can package it up for freighting Australia wide.

$400

Edited May 28, 2016 by dat2kman

[gav240z]

Any photos of how these look when installed? Trying to determine if they would be a good idea for my garage / situation.

[dat2kman]

Dont have a car to show installed!

If you have a bare shell, or one without front x member and no rear suspension, the rear pins drop into brackets on the crossbeam,

The wheel posts are within the bdy, ie the beams dont stick out past the guards.

Few of the past Qld guys have borrowed these, with good results!

 

No need for them now!

[gav240z]

I plan to remove the front and rear cross members to rebuild those components off the car and paint them in KBS rust seal etc.. it would be helpful also to be able to wheel the shell around.

 

How high does the car sit off the ground with these attached? It might also help me with floor repairs since I don't have a rotisserie at the moment.

[dat2kman]

Yes wheels allow full rollability, they swivel 360 deg ( all four)

With one side at lowest setting, other side at highest thefloorpan is around 35 degrees up from horizontal, due to the wind up/down function ( by hand on each post) elevation is approx 700 mm but using some carefully placed blocking, can get it higher.

[Triptych]

Where was this 2 months back.... Im now broke and just finished the first phase of the engine stand rotisserie. 

[gav240z]

PM sent Jason.