General Forums > Recommended Businesses

Magna Spot stud welder

(1/2) > >>

Scoota G:
Just arrived from the states and 1/2 price of comparable items. Just wire in a plug and you're set to go.

Zedman240:
Nice..runs on 240/50Hz and not 110/60Hz?

Scoota G:
Yes dimitri, it was the only 220 240 volt one i could find. The others looked better with their camo design but i tried this on today and it works a treat. $550 delivered.

nat0_240_chevZ:
looks like a 'Rothenberger' copy.....
how ma??
I Use the rothey alot,
pins get expensive here in aus but, not too bad as i re-use them till their 20mm long.....
nat0

zzzzed:
I was using a rothenberg for stud pulled for years. But I recently purchased an eagle 2 which is a shiver load better. You don't need studs as it welds te pulled its self to the panel. And once you have made the pull iu just twist and it's off. It's cut my repare time in half.

Navigation

[0] Message Index

[#] Next page