MattB

Sweet - thanks guys. Id been into clarke rubber but drew a blank. Ill try again #17.

I'm desperately chasing some of this. Where did you get it? Local rubber suppliers don't have anything that would do the job. Thanks

Yep they are yellow. I'm a bit hesitant to cut springs, even just a coil or two. Do kings do a "superlow" or similar as they do for some other makes?

Hi, I'm new to the whole z car scene. But I a fairly experienced in car modifications with other makes. I've not long bought this 240z and I'm slowly adjusting it to meet my plan for it. Recently I fitted a set of watanabes and this has served to highlight the difference in ride height between front and rear. I'd like to lower the front a little, but I think it may already have lowered springs. Is there a way to tell what springs it may have? Could anyone measure theirs (from standard guard lip to wheel center ) so I can compare. I'm hoping it is just a case of getting the next lowest aftermarket spring to make it look right. Is there any other way to tell what is in there? Thanks!