Hello all. Not sure if it is considered bad forum etiquette to sign up and try to sell something in your first post, but at least I'm not flogging junk ;-) I've had this engine wrapped up in gladwrap for a few years now and I really need to shift it to make room. I hope to sell it and the rest of the running gear as I've bought an LS and am thus going the V8 route. The engine started with the triple 45's, and cylinder head. The ported head didn't even get to do 500 kilometers on the road before I pulled the engine out to recondition the bottom end. I got the motor mostly bolted back together and that is as far as it got. As can be seen from the photos, the head has had a lot of work done to it and is pretty thoroughly ported, OS valves, etc. The camshaft is from Watson Racing. I can't remember the specs ATM; I've got the card in a drawer somewhere and have to hunt for it, but it's fairly wild. This head was assembled properly; custom lash pads were actually made to retain the correct rocker arm geometry. Is fitted with a brand new adjustable cam sprocket and chain (Rollmaster brand IIRC). The head has been bolted to the block with ARP studs. As for the bottom end, it's had all the usual done: acid dipped, bored (with a torque-plate), honed, washed, blah, blah. Pistons are brand new (of course) Hypertec which have been individually fly cut for both in and ex valve clearances. Crank has been machined. All mains and big-end bearings new. I have everything to complete the engine even if it's not all currently shown in the photographs (Still have to unbox) - rocker cover, oil pump, two spare sumps, etc. The triple 45 Webers were bought brand new and have seen no more than 10,000 kilometers of use. They are currently fitted with 36mm chokes and I have a set of 32's on the shelf. The intake mainifold is by Redine (not the best) but it has been thoroughly ground out match-ported to the head. The power target for this engine was ~270 hp. I also had a 5sdp 240Z gearbox put together / rebuilt for this thing by Datsport. It is internally mint and has only done a few thousand kilometers on the road after being done (was rebuilt with good bits taken from several donor boxes). This is also for sale, but no photos ATM as I have to pull it out of the junk pile. I'd be happy to crack it open for inspection for any prospective buyer. Along with the gearbox also goes an essentially new Extreme brand heavy duty clutch. I also have two R180 differentials for sale that are mechanically A1. One is a 4.65:1 ratio and the other 3.9:1. As per the gearbox these are currently buried in crap and I'll be more than will to crack open for internal inspection. And I had a nice/complete 2.5" custom exhaust system made for the car (260Z couple) which too has only seen a few thousand kays of use. I don't need that anymore either so It's for sale along with the extractors. I'm located near Adelaide. It should go without saying that all of the above owes me a fair bit of coin, so I'm open to decent/fair offers. I'll get around to pulling out and photographing the other stuff in a few days if there is any legitimate interest at all. Cheers, Glen