Natez Posted February 18, 2006 Posted February 18, 2006 Has anyone done this yet, on there website it says 250kpa, but no needle size will do it with 2mm but not sure if it should be 2.5mm , im doing the wheel well, and floors and rails and basically everywhere that rusts normally on Zs... haha... Quote
warrenz Posted February 19, 2006 Posted February 19, 2006 I brushed it on when I did it. Not that you see it afterwards but finish did not look like a brush job. Spraying would get it into the more difficult areas. Warren Quote
Natez Posted February 19, 2006 Author Posted February 19, 2006 im buying it tommorrow, i think it will befaster as well to spray on... as i am doing alot of the car... thanks Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.