rb20/25 -> s30 engine mount brkts and g-box cross member...early type

Hi guys, see pics.

drivers side engine mount has been slotted to allow the engine to tilt less and sit a bit lower on the drivers side.

utilises the common r31/r32 type skyline mounts, made from 4.0mm Mild Steel HA350 Grade.

Gearbox crossmember is to suit an rb20/30 gearbox with these mounts (manual of course)

Engine mounts sit the engine back as far as reasonably possible ie the shifter pokes out through the auto tunnel in my car, if yours is a manual s30 then i think its even better.

Back of head is approx 50mm from firewall

gearbox crossmember sits mount back about 45-50mm to suit the engine sitting about 50mm back to the std position of the skyline mounts.  Made from 3.0mm HA350 mild steel

This x-member suits  the early style gearbox mounts ie the bolt up type, not the bolts forward/back

any q's please ask, happy to answer.

asking $200 for the 3 mounts (no rubber isolators) cheap new ones on evilbay

cheers nat0

pm  or reply in this thread only please

and...

Guys, thanks for all your interest,

please check weather or not the gearbox mount is the same as your car,

1.  -ie the bolts that bolt it to the car go upwards, 'earlier type' about 'pre 1972'

2.  -if the mounting bolts go through 2 ears with holes on each side ie 'large long bolt' goes front to back, - 'later type' from 73 onwards.

If you need the later type let me know as my mate may have one available soon,

also the engine mount on drivers side, has had the holes slotted downward to allow the motor to sit lower on this side,

stops the brake booster fitting ontop of the r34 rb25 inlet rubbing bonnet,

the r33 models have this fitting at back of manifold so not really the same problem

any q's please pm me.

nat0

may have an rb-s30 sump, custom built also available soon, as the 200zr one from nissin is no longer available and stock aorund the world seems to have disappeared........

later style gearbox mount will also be up for grabs soon.

Engine mounts are still available but have sloted holes via a die grinder.

nat0

new pics added in first post,

suits: rb** with a *71c gearbox into an early s30 combo

the ones pictured are destined to help power bobsyouruncle.....

nat0

1 set available,

going different direction with my RB swap, much more involved,

so this set up for grabs.

enquire within? or PM etc.

Nat0

PM Sent