Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 07/06/2019 in all areas

  1. 1 point
    JDM-TOY

    The Build 73 240Z

    Hey Gavin Its Mick at Race Solutions he is the fabricator at the shop. When I purchased the engine I didn't buy the twins, they were R33 twins.
  2. 1 point
    Hey FYI Performance wheels here in OZ offer custom one off wheels and machining. They are actually building lots of wheels in small batches for overseas wheel brands to. If you can get a wheel they can 3D scan to. The cost is high but for oz made I thought it was very reasonable. Could be an option? cheers dan
  3. 1 point
    JDM-TOY

    The Build 73 240Z

    Box of tissues needed Progress on the fabricating turbo manifold and dump pipe. I decided to Go with a Garrett Gen2 GTX34/82R due to its mid to top range power, no lagging needed. With a built engine could get 500kw of power which im my mind is too much for this car, not that it doesn't deserve it .
  4. 1 point
    AndBir

    Home Built Z 'full Video Build'

    From your last video, if you find you do need a new oil pressure gauge then try Rob at : http://www.zfactory.com.au/contact.htmlhttp://www.zfactory.com.au/contact.html
  5. 1 point
    MaygZ

    Rear air dam 240z , 260z

    I know that at times the written word does not convey the subtle nuances of the English language, but your response has come across as more hostile than is necessary in these circumstances. My comments were meant to assist you and any potential purchasers that in order to use on the road some modifications would be needed. If my message conveyed anything else to you, then I am sorry. Each of us have some knowledge and advice to share with this community. That is one of the many beauties and purposes of this forum. I know that some on-line forums actively require members to harass and abuse others - some even require it - but this is not one of those sites. This site is about help and most of the members regard the other members as a type of family. I do hope that you stay around long enough to find that out and that you haven't burnt too many bridges by that time.
  6. 1 point
    MaygZ

    Rear air dam 240z , 260z

    I don't want to be a party pooper, but your side skirts do not comply with the ADRs and would make a vehicle unroadworthy. All forward facing protrusions from the vehicle must have a radius of at least 10mm to comply. It doesn't look to be difficult to alter your skirts to comply, but that may have an affect on the aesthetics. MaygZ
×
×
  • Create New...