Drivetrain and parts for a 260Z

[wildy55]

Morning all

After owning three 240Zs over the years, I’ve now got skin in the 260Z game. 
Managed to buy a project 75 2-seater. For some reason only known to themselves, the previous owner had plonked a Rover V8 between the chassis rails. Luckily it was only a test fit and no bodywork was modified. 
So looking for the following to go in the car:

L28 engine (complete - carbs and exhaust - but will consider any parts or condition)

5-sp manual box

Engine x-member and mounts

Gearbox x-member and hardware

Front suspension tension rods and hardware

Manual pedal box or just pedals and pivot rod

Front valance panel

Wiper cowl panel

RH inspection flap panel

RH fresh air-to-inner fender boot

Centre console

Air-to-cabin flap knob

Any help finding these bits will be greatly appreciated. 

On the Gold Coast but will cover postage  

I’ll start a build thread when I get deeper into the old girl

Cheers 

Martin

[Agno]

Hi Martin, I've got LCAs and tension rods if you need them.

Alex

[C.A.R.]

I'll swap you a close ratio 260Z 5-speed for the Rover V8...?

[wildy55]

5 hours ago, Agno said:

Hi Martin, I've got LCAs and tension rods if you need them.

Alex

Pmd 

[wildy55]

1 hour ago, C.A.R. said:

I'll swap you a close ratio 260Z 5-speed for the Rover V8...?

Pmd

[peter t]

Hi Martin I have got a couple of inspection flaps spare. Plus a set of round tops and manifold. Long time no see mate.

 

Edited December 8, 2021 by peter t