Jump to content
Bobby

Cannon manifold for three Webers.SOLD

Recommended Posts

I have for sale a Cannon inlet manifold and the linkages for three Webers that was on my 260Z when I bought it.

None of the studs that hold the carbys were square to the face-I have corrected this and made all to a length for soft mounts.

Where the bolts go through the manifold to mount it to the head was not flat-I have milled all of these to give a consistent thickness which makes it easier to match to extractors.

I have made up new mounting points for the three support rose joints to get better actuation onto the carbys.

Note to get the rod as close as possible to the carbys I machined a little off where the choke cable would be. You will either have to do this or go back to the original setup for the rose joints.

I have made all the linkage you see in the photos including the universal joint.

Manifold has been vapour blasted for a more durable and better looking finish.

My carbys were 40mm so I don't know if they are all the same externally.

$300

I live at Newcastle NSW.

P1100181.JPG

P1100182.JPG

P1100184.JPG

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...