manyu Posted May 28, 2018 Share Posted May 28, 2018 (edited) Hi Guys,I have a fairly rusty 2+2 that I'm scavenging some parts off. Just wondering if there is any interest in specific metal cuts that bus restorers are looking for before the shell gets scrapped completely. Sills and doglegs are useless, ask about specific pieces and I'll check for you. Also have a pair of front seats for sale, drivers side has rips but still very save-able - $400 Air conditioning Compressor, bracket, lines, receiver dryer, and condenser - $550 for the lot of that. Parts Sold: Bumpers and grillRear beaver panel grommetsFront indicator housings and lenses Located NSW 2769. Edited May 31, 2018 by manyu Quote Link to comment Share on other sites More sharing options...
Cozza Posted May 28, 2018 Share Posted May 28, 2018 Not sure if the front indicator lens and housing is the same as a 240z but definitely interested in left and right if they are. Thanks, Mick Quote Link to comment Share on other sites More sharing options...
Administrators gav240z Posted May 28, 2018 Administrators Share Posted May 28, 2018 Mick no 260z ones have a split amber / clear signal assembly. You can plug it into a 240z though. Car looks nice actually. Shame she will get the chop! Quote Link to comment Share on other sites More sharing options...
Andrew_L26 Posted May 28, 2018 Share Posted May 28, 2018 Hi Guys, I have a fairly rusty 2+2 that I'm scavenging some parts off. Just wondering if there is any interest in specific metal cuts that bus restorers are looking for before the shell gets scrapped completely. Sills and doglegs are useless, ask about specific pieces and I'll check for you. Also have a pair of front seats for sale, drivers side has rips but still very save-able - $400 Bumpers and grill sold. Located NSW 2769. Hey mate, would be keen on the bonnet. Also how is the section that the hatch bolts too? Quote Link to comment Share on other sites More sharing options...
Cozza Posted May 28, 2018 Share Posted May 28, 2018 Ahh, thanks for that Gav. I will pass on them in that case. Thanks again. Mick Quote Link to comment Share on other sites More sharing options...
manyu Posted May 28, 2018 Author Share Posted May 28, 2018 Mick no 260z ones have a split amber / clear signal assembly. You can plug it into a 240z though. Car looks nice actually. Shame she will get the chop! Hi Gav, It's worse than it looks, floors and rails are pretty good, but not much else that can be saved. But it's helping put another one on the road. Hey mate, would be keen on the bonnet. Also how is the section that the hatch bolts too? Hi Andrew, Bonnet I'll be keeping for mine mate, sorry. Rear of roof where the hatch bolts to is rusty, but I'll send some pictures this week and you can PM me if you're still interested. Ahh, thanks for that Gav. I will pass on them in that case. Thanks again. Mick Sorry Mick, don't have anything that'll help you. Quote Link to comment Share on other sites More sharing options...
lightmaster240z Posted May 28, 2018 Share Posted May 28, 2018 I would be up for the indecator if you are parting with them ? Just pm your price and details Bruce manyu 1 Quote Link to comment Share on other sites More sharing options...
YellowRX Posted May 28, 2018 Share Posted May 28, 2018 Pm sent manyu 1 Quote Link to comment Share on other sites More sharing options...
Impatient1 Posted May 28, 2018 Share Posted May 28, 2018 How does the fuel filler section look? gav240z and manyu 2 Quote Link to comment Share on other sites More sharing options...
Simestime Posted May 29, 2018 Share Posted May 29, 2018 Does it have the vent pull tab bits? And clock?..... Quote Link to comment Share on other sites More sharing options...
Simestime Posted May 29, 2018 Share Posted May 29, 2018 Actually i dont mind that colour blue. It does need love but is that an original colour? Quote Link to comment Share on other sites More sharing options...
Administrators gav240z Posted May 29, 2018 Administrators Share Posted May 29, 2018 Actually i dont mind that colour blue. It does need love but is that an original colour? Yeah I kind of like the gunmetal-ish shade on it. I think the interior is brown which usually means it was a bronze exterior car. I'm guessing by radiator support that it's a later 76+ model. Quote Link to comment Share on other sites More sharing options...
Administrators gav240z Posted May 29, 2018 Administrators Share Posted May 29, 2018 If you're cutting it up, I'm potentially interested in the window pillars (both sides). Refer to pic here as to why. But would prefer the cut to be a little more than just the pillars if you know what I mean? Quote Link to comment Share on other sites More sharing options...
gilltech Posted May 29, 2018 Share Posted May 29, 2018 Not 100% sure as I've never been in a position to check but I believe the 2+2 A-pillars are slightly heavier, and using a thicker pinch weld, I suspect req'd due to the longer/heavier doors. I believe that's why the difference between 2-seat and 2+2 windscreen rubbers. Correct me if I'm wrong. Quote Link to comment Share on other sites More sharing options...
Gyzmo Posted May 29, 2018 Share Posted May 29, 2018 In what condition is the fuel filler flap and recess?Interested to purchase... Quote Link to comment Share on other sites More sharing options...
Gyzmo Posted May 29, 2018 Share Posted May 29, 2018 I am also interested in the roof from top of front and rear pillars as well as the fuel filler recess and flap... Quote Link to comment Share on other sites More sharing options...
Gyzmo Posted May 29, 2018 Share Posted May 29, 2018 PM Sent... Quote Link to comment Share on other sites More sharing options...
Simestime Posted May 29, 2018 Share Posted May 29, 2018 In what condition is the fuel filler flap and recess? Interested to purchase... I have a spare flap off a 2+2 in good condition if this one here is no good. Quote Link to comment Share on other sites More sharing options...
Administrators gav240z Posted May 29, 2018 Administrators Share Posted May 29, 2018 Not 100% sure as I've never been in a position to check but I believe the 2+2 A-pillars are slightly heavier, and using a thicker pinch weld, I suspect req'd due to the longer/heavier doors. I believe that's why the difference between 2-seat and 2+2 windscreen rubbers. Correct me if I'm wrong. In that case I might hold off until I can confirm.. Quote Link to comment Share on other sites More sharing options...
manyu Posted May 29, 2018 Author Share Posted May 29, 2018 (edited) Updated first post with sold items. Replied to all PM's and posts in order. I would be up for the indecator if you are parting with them ? Just pm your price and detailsBruce Sorry Bruce, first things to go. Pm sent Replied How does the fuel filler section look? Plenty of rust, flap itself is okay. Does it have the vent pull tab bits? And clock?..... Has vent pull tabs, but I'm keeping the clock to play with sorry. It doesn't work, I want to try and bring it back to life. Might sell it if it works at a later stage. Actually i dont mind that colour blue. It does need love but is that an original colour? Not original, someones gone over it very poorly. Yeah I kind of like the gunmetal-ish shade on it. I think the interior is brown which usually means it was a bronze exterior car. I'm guessing by radiator support that it's a later 76+ model. 306 Silver original, 77 model yes. PM Sent... Replied. Edited May 29, 2018 by manyu Quote Link to comment Share on other sites More sharing options...
lightmaster240z Posted May 29, 2018 Share Posted May 29, 2018 All good . The old saying on the forum you snooze you loss. Quote Link to comment Share on other sites More sharing options...
Simestime Posted May 29, 2018 Share Posted May 29, 2018 Pm sent. Quote Link to comment Share on other sites More sharing options...
manyu Posted May 31, 2018 Author Share Posted May 31, 2018 All PM's replied to. Also have all air conditioning setup for sale. Compressor, bracket, lines, receiver dryer, and condenser. After $550 for the lot of that. Quote Link to comment Share on other sites More sharing options...
74zzz Posted May 31, 2018 Share Posted May 31, 2018 not sure if their up for sale but im keen on the three front valance pieces if they are reasonable? Quote Link to comment Share on other sites More sharing options...
datmoo Posted May 31, 2018 Share Posted May 31, 2018 (edited) Interested in the transmission tunnel. Here's mine: and bonnet hinges. Edited May 31, 2018 by datmoo Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.