Jump to content
Gtv240z

Datsun 240Z 260Z Coolant Pipe, 3 Way Water Pipe, Connector For Heater Hoses

Recommended Posts

Hi there, I would like to purchase one of these heater hose connectors. I would also like to purchase the longer one that goes around the back of the motor if you have these.

regards

John

Share this post


Link to post
Share on other sites

Hi there, I would like to purchase one of these heater hose connectors. I would also like to purchase the longer one that goes around the back of the motor if you have these.

regards

John

Hi John, 

Unfortunately I cant really get these ones , some versions do still appear to be available out of the US.

I do have in stock the elbow fitting for the heater hose that screws into the cylinder head.

 

I have pm'd you

 

Thanks

Share this post


Link to post
Share on other sites

John,

A while back the vendor 'nissandatsunparts' on eBay was advertising that same coolant pipe, NOS, check with him I don't know whether it sold but he may have had more than one in stock.

Worth a try anyway, he advertises various Zed odds and sods from time to time.

Share this post


Link to post
Share on other sites

About 5 years ago I walked into Nissan spare parts and asked for this 3 way pipe along with the pipe that ran around the back of the engine.

 

We found the part numbers on the microfiche and he ordered them for straight on the spot... not sure if anyone can still try Nissan themselves.

Gav as for the pipe you're talking about, I think it may be much faster to find a suitable pipe, buy new screw plug fasteners, and go to a brake shop and get them to flare the ends of the pipe with the fasteners on it.  I doubt anyone would pick up that it's not original once it's been used for a while - obviously just want a metal that can take the heat and not expand/contract too much.

 

Share this post


Link to post
Share on other sites

Thanks I've dropped the manifold off to Lachlan in Warragul who is going to have the parts blasted and re-plated. I suspect he knows of a source for that center pipe. I agree on the originality aspect, nobody would know. :D

Share this post


Link to post
Share on other sites

Getting a bit off track from the original post here...

 

Gav...is this the pipe you are referring to?  on the two carbie manifold stets that I have the " pipe" is  10mm OD tube.... I bought some from a hydraulic shop in town and it was zinc plated. 

There is no flaring but a rubber ring is used part number 14013-73400 and this would allow for expansion. I cant find the two rubber rings at the moment...must be in super storage 

aka lost :-[.

I hope this helps.

IMG_1511 (002).JPG

IMG_1512 (002).JPG

Edited by PeterH

Share this post


Link to post
Share on other sites

Hi Have you still got any of the three way coolant pipes for a 260z to sell?

Share this post


Link to post
Share on other sites

Ok,  thanks for that but at this time I have decided to eliminate the need for a three way set up and disconnect the water flow to the carbs.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...