showtime Posted May 2, 2010 Share Posted May 2, 2010 I have upgraded my front and rear sway bars 28 front and 24 rear but i need strut bracing to finish me handling needs i have tried whitlane,vpw,nolathane and signature does any know who make them in Australia? Quote Link to comment Share on other sites More sharing options...
nat0_240_chevZ Posted May 2, 2010 Share Posted May 2, 2010 i have made a zx one previously for a young chap here in adelaide. dont have any templates etc as it was made to suit his car and as i had his car there i didnt need to. I think i have the drawings but for the strut tower tops. bonnet clearance is a bit of a pita to get right, they were solid and in mild steel, ie no pivots fully welded. nat0 Quote Link to comment Share on other sites More sharing options...
Hunter Posted May 2, 2010 Share Posted May 2, 2010 Cusco versions from MSA http://www.thezstore.com/page/TZS/CTGY/PSDC04 They are a bit more expensive than the MSA versions I just bought for my 240Z, shipping is reasonable, and exchange rate should be ok at the moment. I had US$920 worth of gear sent over in two big boxes from MSA, cost about $300 for postage. For just two strut bars that should be a fair bit cheaper. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.