Jump to content


Photo

ALL PARTS SOLD!!


  • Please log in to reply
48 replies to this topic

#1 spiderken17

spiderken17

    Advanced Member

  • Members
  • PipPipPip
  • 59 posts
  • Location:Blue Mountains NSW
  • Tagline:New Member

Posted 03 May 2011 - 07:08 PM

Since  i have had very little interest in the car as a whole i have decided to break it up as parts (this way i get to keep the engine/gearbox for another project)

The following items are from my 1977 260Z 2+2.
I am located in the Lower Blue Mountains/ Penrith area. However, I am in St Marys often and go to Wetherill Park 2 days a week. I also travel up to Cessnock regularly and down to Ulladulla a few times a year.
I will also be going down to Winton, VIC on the 19th of May for the V8's.
If need be i can drop things off to any of these locations (or on the way) depending on timing to make things easier for buyers.
I have the following items:

Dash in excellent condition which is uncracked and has little to no marks on it - $400.00(cheaper than getting one reskinned) SOLD

Posted Image

Centre console in excellent condition with little to no marks on it with rechromed ash tray lid - $180.00 SOLD

Posted Image

Fibreglass front spoiler. Brand new in the plastic - $200.00 (cost me $250.00) SOLD

Posted Image

Unmarked 14 inch alloy wheels with tyres (90% tread, 195 fronts, 205 rears) - $100.00 SOLD

Posted Image

Rechromed passenger side footrest - $50.00 SOLD

7 inch round crystal headlights - $30.00 (retails for $50.00) SOLD

All items are plus postage. Couriers to be organised by the buyer.

The rest of the car is getting wrecked out on this thread http://www.viczcar.c...2.html#msg87282
Feel free to ask any questions.

Contact me on spiderken17@yahoo.com.au

Cheers, Ken



#2 wildy55

wildy55

    Advanced Member

  • Members
  • PipPipPip
  • 424 posts
  • Location:Goldie

Posted 03 May 2011 - 10:12 PM

PM sent re headlights

#3 slimerz

slimerz

    Member

  • Members
  • PipPip
  • 26 posts
  • Location:USA
  • Tagline:New Member

Posted 04 May 2011 - 04:01 AM

Do you have the turn signal and headlight switch assembaly?  If so how much? Also how much for the passenger side foot rest I saw on the other page?

Thanks Mike

#4 luvemfast

luvemfast

    The 2000+ club

  • Members
  • PipPipPipPipPipPipPip
  • 4,136 posts
  • Location:Melbourne

Posted 04 May 2011 - 07:52 AM

Do you have the turn signal and headlight switch assembaly?  If so how much? Also how much for the passenger side foot rest I saw on the other page?

Thanks Mike

Hi Mike,
Being that you're from the US.....
The passenger side foot rest are acually the drivers pedals  ???
Here to help,
the other Simon

#5 spiderken17

spiderken17

    Advanced Member

  • Members
  • PipPipPip
  • 59 posts
  • Location:Blue Mountains NSW
  • Tagline:New Member

Posted 04 May 2011 - 05:18 PM

Also for sale
Reproduction tailgate seal (on the body). This is not a length of rubber which needs trimming to fit but a closed loop of seal that fits the tailgate - $50.00 (cheaper than retail) SOLD

Brand new Pierburg electronic 12 volt (6.3 to 8.1 psi) fuel pump. High quality. Part no. 3.45220.57 - $50.00 (retails for well over this) SOLD

#6 slimerz

slimerz

    Member

  • Members
  • PipPip
  • 26 posts
  • Location:USA
  • Tagline:New Member

Posted 04 May 2011 - 09:38 PM

Im actualy going to convert a u.s. 240 to a RHD car.  Thats why I'm so interested in these parts.  The other part I would like to know a price on would be the steering column bracket.

Thanks, Mike

#7 spiderken17

spiderken17

    Advanced Member

  • Members
  • PipPipPip
  • 59 posts
  • Location:Blue Mountains NSW
  • Tagline:New Member

Posted 05 May 2011 - 06:38 PM

If possible could people please email me directly on spiderken17@yahoo.com.au with the part they are after as a heading, its confusing jumping from multiple forums to email keeping track of things.
Cheers, Ken

#8 paulz

paulz

    Advanced Member

  • Members
  • PipPipPip
  • 40 posts
  • Tagline:New Member

Posted 05 May 2011 - 08:00 PM

Hi i will gladely buy the wheels ken
regards Paul email already sent

#9 wildwildwhoosh

wildwildwhoosh

    Newbie

  • Members
  • Pip
  • 8 posts
  • Location:NSW
  • Tagline:New Member

Posted 06 May 2011 - 03:35 PM

PM sent re center console.  Cheers!

#10 spiderken17

spiderken17

    Advanced Member

  • Members
  • PipPipPip
  • 59 posts
  • Location:Blue Mountains NSW
  • Tagline:New Member

Posted 07 May 2011 - 11:18 PM

Did some sorting, here is a list of parts i still have to make things easier

Bonnet - some surface rust and old repairs. SOLD
LH/RH Guards - small amount of  rust, some small dents.
LH Door - stripped to bare metal, a few rust holes and small dents. not a bad door.
Tailgate - no rust or damage.
Bonnet Hinges - Good SOLD
L26 Radiator and fan cowl - Worked fine when it was in the car
L26 starter Motor - worked fine before the engine came out of the car
LH/RH headlight surrounds - LH one looks good, RH appears to have some repairs on it
LH/RH Headlight buckets - fine
7 inch Halogen headlights - H4 replacements for the old sealed beam units SOLD
Tail lights/number plate lights/surrounds - Lenses, chrome surrounds and all the painted surrounds(stripped to plastic and painted in 2 pack, gunmetal grey)
Grille - fine, could use a repaint
LH/RH door stainless window frames - good
LH/RH interior door opening mechanisms, handles and rods - works great
LH/RH door window mechs and - good
Washer bottle/ battery cover - mostly stripped, very good, no rust or repairs SOLD
All Glass - frt screen (has a few chips), rear screen, LH/RH side glass, LH/RH qtr windows.
Gauges - speedo (odo reads 96xxx kms), tacho, temp/oil, volts/fuel, clock, all worked when the car last ran
bonnet cable - good with good bonnet release handle SOLD
speedo cable - from speedo to gear box, good SOLD
front/rear bars - both have some dents and marks, the rubber bump strips are cracked
fuel flap - no dents SOLD
L26 engine airbox - factory blue, some surface rust/ flaking paint
stainless body moulds (door belt moulds, Qtr window appeture moulds, gutter moulds, windscreens and any other bits) - a few marks on some, most of them are near perfect. REAR SCREEN MOULD SOLD
   
Feel free to ask any questions. If you are after pics email me so i cn email pics back as it is quicker and easier.

#11 spiderken17

spiderken17

    Advanced Member

  • Members
  • PipPipPip
  • 59 posts
  • Location:Blue Mountains NSW
  • Tagline:New Member

Posted 08 May 2011 - 09:25 AM

More stuff

LH/RH stainless window frames - good
2 steering wheels -  both are rough and need a retrim
front brake calipers - need a rebuild SOLD
exterior door handles -a little worn SOLD
washer bottle - not cracked but not perfect, just old
Rolling Shell with all suspension/fuel tank/diff and C/V shafts - little bit of rust and old repairs (details here http://www.viczcar.c...pic,9088.0.html) good if your shell is buggered, little bit of work and it would be a good shell.

and if someone wants my interior for FREE they can have it. Alot of it is rubbish but some of the plastics are OK. Interior is pick up only ALL GONE

#12 YosemiteZed

YosemiteZed

    Advanced Member

  • Members
  • PipPipPip
  • 100 posts
  • Location:Mid North Coast,NSW
  • Tagline:Rust never Sleeps

Posted 08 May 2011 - 08:03 PM

PM sent on trim and H4 lights

#13 wildy55

wildy55

    Advanced Member

  • Members
  • PipPipPip
  • 424 posts
  • Location:Goldie

Posted 08 May 2011 - 09:15 PM

Have mailed you re lights and windscreen.
Cheers Martin

#14 spiderken17

spiderken17

    Advanced Member

  • Members
  • PipPipPip
  • 59 posts
  • Location:Blue Mountains NSW
  • Tagline:New Member

Posted 12 May 2011 - 08:48 PM

A few more things.
LH/RH door metal window channels (in the door) - good
Centre dash vent panel (where the centre console meets the dash) - a few small marks, pretty good
Tailgate gas struts - still good
2+2 Tailshaft - good
All badges in various conditions - not too bad


#15 spiderken17

spiderken17

    Advanced Member

  • Members
  • PipPipPip
  • 59 posts
  • Location:Blue Mountains NSW
  • Tagline:New Member

Posted 24 May 2011 - 10:01 PM

Revised list of parts with prices

Fibreglass front spoiler. Brand new in the plastic - $200.00 (cost me $250.00)
LH/RH Guards - very small amount of  rust, some small dents - $100 each
LH Door - stripped to bare metal, a few rust holes and small dents. not a bad door - $80
Tailgate - no rust or damage - $150
L26 Radiator and fan cowl - Worked fine when it was in the car - $50
L26 starter Motor - worked fine before the engine came out of the car - $40
LH/RH headlight surrounds - LH one looks good, RH appears to have some repairs on it - $50 for the pair
LH/RH Headlight buckets - fine - $20 for the pair
Tail lights/number plate lights/surrounds - Lenses, chrome surrounds and all the painted surrounds(stripped to plastic and painted in 2 pack, gunmetal grey) - $100 the lot
Grille - fine, could use a repaint - $20
LH/RH door stainless window frames - good - $25 each
RH  interior door opening mechanisms, handles and rods - works great - $20
Front screen - has a few chips $30
Rear Screen - good - $150
Speedo/Tacho -  (odo reads 96xxx kms) - $50 each
temp/oil,  clock, all worked when the car last ran - $30 each
front/rear bars - both have some dents and marks, the rubber bump strips are cracked - $20 each
L26 engine airbox - factory blue, some surface rust/ flaking paint - $40
LH/RH Qtr window belt moulds - $20 each
LH/RH gutter moulds - $20 each
LH/RH door belt moulds  - near perfect -$30 each
Centre dash vent panel (where the centre console meets the dash) - a few small marks, pretty good - $20
Tailgate gas struts - still good - $20 the pair
2+2 Tailshaft - good - $30
LH door hinges - good - $30 the pair
All badges in various conditions - not too bad - $30 the lot
LH/RH Qtr glass in stainless frames - $30 each
Front screen chrome moulds (goes in the screen rubber)

Rolling Shell including all suspension/fuel tank/diff and C/V shafts - little bit of rust and old repairs, good if your shell is buggered, little bit of work and it would be a very good shell - detailed pics here http://www.viczcar.c...pic,9088.0.html$750.00
Posted Image
I can arrange transport for the shell if it is not too far from home.
Feel free to ask any questions or about smaller items as i have everything bagged up.

#16 spiderken17

spiderken17

    Advanced Member

  • Members
  • PipPipPip
  • 59 posts
  • Location:Blue Mountains NSW
  • Tagline:New Member

Posted 31 May 2011 - 08:49 PM

Airbox and grille sold
Anyone interested in the shell as i would like it gone as i could use the space.

#17 FLEXZED

FLEXZED

    Senior Member

  • Members
  • PipPipPipPipPip
  • 779 posts
  • Location:sydney
  • Tagline:Loui

Posted 31 May 2011 - 10:24 PM

Hey mate

i would be interested in the radiator support before you get rid of the shell

Loui

#18 spiderken17

spiderken17

    Advanced Member

  • Members
  • PipPipPip
  • 59 posts
  • Location:Blue Mountains NSW
  • Tagline:New Member

Posted 01 June 2011 - 07:47 PM

The shell is going on ebay on thursday if anyone is interested.

#19 spiderken17

spiderken17

    Advanced Member

  • Members
  • PipPipPip
  • 59 posts
  • Location:Blue Mountains NSW
  • Tagline:New Member

Posted 05 June 2011 - 09:02 AM

Shell is now on ebay. http://cgi.ebay.com....=STRK:MESELX:IT

I also found a Haynes manual and original factory manual. $10 plus postage for both.

#20 spiderken17

spiderken17

    Advanced Member

  • Members
  • PipPipPip
  • 59 posts
  • Location:Blue Mountains NSW
  • Tagline:New Member

Posted 12 June 2011 - 10:40 AM

Dash is sold.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users