Sadly guys it has come time to part with what was going to be my project.
Due to the amount of rust in this car as well as I now only have a single car
garage to work with for the moment. I have decided its best to part with the girl
and start saving and buy something thats almost complete or is complete.
She is a 75 260Z 2+2.
Before I started pulling the car apart I ran the engine and drove it around the block
a few times. Engine seems to run well and didnt feel anything funny in the auto.
I have almost all of the interior pieces although they are a bit second hand.
From the work I have started there is rust in the drivers sill panel, the rear 1/4
around the fuel filler and also where it meets the hatch, There is a rust hole next to
hatch hinge so I believe there is more than likely rust hiding under the roof too.
There is also a squarish hole in the passenger side floor.
I deally I would like to sell it as a complete car and parts. What has been removed
from the car so far is mostly boxed up and labelled. However if there is enough interest
in specific parts I will look at removing this add and parting out the car.
As car is partially stripped it will need to be towed and is located in Wyndham Vale (western Melbourne)
I know I wont get much if anything at all back on what I spent and thats ok.
Given the amount of rust and work needed I am open to reasonable offers for
cash on pick up.
I have attached the link to the build thread for this car which has some pictures in it
and I will happily supply anymore on request. I will also try get some more pictures
of the specific rust spots tomorrow.
Feel free to contact me with any questions either via PM or on email AFleming@pacbrands.com.au