« previous next »
Pages: [1]

Author Topic: Sleeves/collars for R200 crown wheel bolts  (Read 1903 times)

Offline KatoKid

  • Donating Member
  • Registered User
  • ***
  • Posts: 525
  • Location: South Mexico.... where the low lifes cant find me.
  • Not so New Member but not a Newbie either
Sleeves/collars for R200 crown wheel bolts
« on: August 20, 2010, 07:14:01 PM »
Was reading the following thread http://forums.hybridz.org/index.php/topic/88099-obx-differential-inspection-and-installation/ on Hybidz about upgrading the cheap Chinese OBX LSD which is a knock off of the expensive Quaif diff and found this which may be useful....

If you're doing an R200 upgrade but your centre has the 10mm bolts and the crown wheel has the 12mm holes you can buy http://www.mcmaster.com/#6679k14/=8hfy3s  these sleeves rather that get some made up and they are even the right length as well!

Sorry if its been posted before.
Logged
Husaberg...its half a KTM

My Project: http://www.viczcar.com/forum/index.php/topic,6400.0.html

71 240Z #000728
77 260Z 2+2 Gone but not forgotten.
2012 Husaberg 570FE....giddy up!

Offline Lurch

  • Locky
  • Global Moderator
  • Registered User
  • *****
  • Posts: 3873
  • Location: Victoria
  • Oracle of BS.
Re: Sleeves/collars for R200 crown wheel bolts
« Reply #1 on: August 20, 2010, 07:46:28 PM »
Nice research Dave! :D
Logged

Offline Whittie

  • Registered User
  • *
  • Posts: 373
  • Location: Perth
Re: Sleeves/collars for R200 crown wheel bolts
« Reply #2 on: August 20, 2010, 08:04:11 PM »
Nice find!

I had to make these up, and it was a lot more money and effort than $3 each!!
Logged
'77 260z 2 Seater - Stock as an F22 Raptor

Build Thread --> http://www.viczcar.com/forum/index.php/topic,6991.0.html

Lots of incar videos --> http://www.youtube.com/user/whittie260

Offline nat0_240_chevZ

  • Registered User
  • *
  • Posts: 598
  • Location: Adelaide
Re: Sleeves/collars for R200 crown wheel bolts
« Reply #3 on: September 01, 2010, 10:33:54 AM »
I made some up too, cost me $0...
but as i used a GTR centre from tomei, they use M13 Bolts?????? yes not a typy, so my spacers wer 1.31od x 10.1 ID x 11mm long from memory........
nat0
Logged

Auszcar 240z, 260z, 280zx Forums

Re: Sleeves/collars for R200 crown wheel bolts
« Reply #3 on: September 01, 2010, 10:33:54 AM »
Pages: [1]
« previous next »