Auszcar Sponsors > Otomoto

Ben's garage (used parts)

(1/8) > >>

BenZed:
I'll be listing parts I have lying around in my warehouse on this thread.

BenZed:
Here I have the wheels from my project car. They are Magnums, made in Australia by Samson Engineering. They are very old, most likely dealer-fitted. I'm not sure of the size but it looks like 14x6.
Good condition overall, light gutter scrapes on the edges but nothing to worry about. They have good tyres too, 205/60 front and rear. One pair is Falken Ziex, about 60% tread, the others are Yokohamas, about 90% tread.

$200 for the set. Maybe a cheap way out if you need tyres for rego ;)

Still available!

BenZed:
Here are a pair of front guards for a 240Z. I was going to use them on my car, so I had rust repair panels welded in and they have been hi-filled. At the last minute I decided to fit fibreglass guards so they have been sitting in the shed since then. They need a bit of a tidy-up before you fit them but they are pretty good overall.
When I did a trial fit they were a bit wrong at the bottom edge (probably due to the shape of the rust repair panel) so you may want to do a bit of work to make sure they'll fit perfectly before you paint them.
With this in mind they are going cheap at $200 the pair, which is less than I paid for the repairs and hi-fill.

Still available!

BenZed:
Steering coupler (replaces the rubber coupler in the steering column) for 240Z or 260Z.
Made by G Machine in Florida. $20 express posted anywhere in Australia.

***SOLD***

BenZed:
Rota RB 16x8 +4 wheels, set of four as-new (no marks of any kind) with Silverstone S-575 semi-slick tyres in 210/625 size (similar to 215/50, not road-legal). The tyres are also near-new, only about 15-20 laps of Wakefield on them.
Basically you're getting new wheels with free tyres because I'm asking $1000 for the set.
These can be picked up from Ingleburn or freight by TNT as follows:
NSW, VIC, QLD $80
SA $100
TAS $110
WA, NT $140

***SOLD***

Navigation

[0] Message Index

[#] Next page