Auszcar Sponsors > Otomoto

HSD coilover sleeve kits

(1/17) > >>

BenZed:
New product I just got in, unlike most weld-on coilover sleeve kits on the market these come with springs AND helper springs AND spanners.
Everything you see in the pic is one set, which is $299. Two pairs for $500.
The 51mm sleeves to suit 240Zs (front or back) come with a choice of 4kg or 5kg springs (224lb or 280lb). I can also supply other rates if needed. The top spring locator has a small 8mm hole so it can be drilled out to suit your struts. Other than that you should just need a few washers to make everything sit right.
PM me if you want a set.

Will:
If your going to make the 55mm coil over kits put me down for the front and rear kit.

Cheers
Will

BenZed:

--- Quote from: Will on April 01, 2009, 06:57:12 PM ---If your going to make the 55mm coil over kits put me down for the front and rear kit.

Cheers
Will

--- End quote ---

I will get these made in about two months. We will have to use 70mm ID springs to suit.

jasonb:
sounds good, ill probably be keen for a set when the larger ones are made:)

BenZed:
55mm sleeve kits are now in stock to suit 260Z struts at $299 a pair.
The 55mm kits use a 70mm inside diameter spring. At this stage we have only 6kg/mm in stock but we can order different rates if you need them.
There is a stepped spacer between the main spring and the helper spring, which is still 65mm ID.
Call 02 8677 4890 to order or PM me.

Navigation

[0] Message Index

[#] Next page