DTF260 Posted January 27, 2012 Posted January 27, 2012 After a Strut assembly for the rear right hand side for my 260z to get it back on the road until i can afford to go down this track http://arizonazcar.com/strassy.html Ive gone and bent the to arms that connect to the control arm... Heres a pic of what im after Quote
Moderators Zedman240® Posted January 27, 2012 Moderators Posted January 27, 2012 I have one here in Melbourne if you can't find one locally.. Quote
DTF260 Posted January 27, 2012 Author Posted January 27, 2012 hmm, you wouldnt happen to know what the postage on it would be would you? Im after a sort of 'band-aid' fix on the cheap. Im hoping to upgrade to the the complete AZC setup when funds allow (in a month or two) and it would be nice to get it on the road for the rego thats due soon. Quote
Moderators Zedman240® Posted January 27, 2012 Moderators Posted January 27, 2012 I can probably send it with hunter xpress for about $20 to a business address. Weight would be around 10ish kg's? Quote
DTF260 Posted January 27, 2012 Author Posted January 27, 2012 sounds good, how much you after for the whole thing inc postage? what do you mean business address? Quote
PeterAllen Posted January 27, 2012 Posted January 27, 2012 ...Ive gone and bent the to arms that connect to the control arm... Are you sure it's not the spindle that's the problem? Quote
Moderators Zedman240® Posted January 29, 2012 Moderators Posted January 29, 2012 If your zed is crab crawling, its the brackets in the pic below that have to be checked to make sure they are exactly 90'. If either or both are bent, they have to be replaced. Item #5 in pic below. Quote
DTF260 Posted February 4, 2012 Author Posted February 4, 2012 Im positive the spindle is ok, the wheel was pushed from the outer rear edge and it seem it was the two arms on the strut assembly that gave up. I had a look under the rear yesterday and it seems they brackets are still fine, although its tough to tell without replacing the obviously bent bit first. Could I grab that assembly off you still Dimitri? Quote
Moderators Zedman240® Posted February 4, 2012 Moderators Posted February 4, 2012 No probz..I thought it was impossible to bend that strut casting for the rear axle. Quote
DTF260 Posted February 4, 2012 Author Posted February 4, 2012 Using the outer edge of the wheel to stop the car from 10 or so km/h seems to do the trick. i hope thats all thats been bent. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.